Having difficulty in making an action get past a certain point...Help!

[MiniChris]

I tried to set up an action to do a layer inversion setup. Each time I go through the process, it stops at gaussian blur, even though I used a preset amount. Has anyone else experienced this problem and if so, how did you fix it?

PS5

[hoddo]

Chris, would you be willing to send it over so I can have a look?

UPDATE

I've just created an action that includes gaussian blur at a set value it running the action didn't stop at the blur layer. In your action palette come out of button mode and inspect your action. You should be able to see the steps...to the left of the steps you will see two boxes next to the gaussian blur layer...one should have a tick and the other I suspect has a folder icon in it. It's this icon that stops your action from running. Click that folder which will disappear and your action will run without stopping.

[MiniChris]

Let me try that first and see what it does, but if it doesn't, I will send you the link. Thanks...weird that it does this as all my other actions seem to work just fine.

[ilovelucydog]

Just curious... did you get it to work?

[MiniChris]

Actually, i haven't tried it again..been too busy getting this seafood job completed. I probably won't get to it until I get back from New Hampshire

[ilovelucydog]

Actually, i haven't tried it again..been too busy getting this seafood job completed. I probably won't get to it until I get back from New Hampshire

If you have free time while in NH... like in the evenings... and you're bored... my basement needs packing.