Helpful Posts:
0
-
5th March 2012, 08:40 PM
#1
B+W Filter mount confusion
Hi Folks,
I am looking to get a B+W filter and am getting confused as to what the XSPD and XSPRO abbreviations with regard to the mount stand for,also I'm concerned about the lens cap being able to fit on over it.Any help most appriciated,Best Wishes,Pat.
-
6th March 2012, 05:16 AM
#2
Re: B+W Filter mount confusion
I use B+W filters I buy the large 77mm ones, and use step up rings, that was I use one size filter arcoss different size lens. I would not worry about the lettering on them, but would suggest that you get the extra slim that is what the XS means. That is so you can use it on a ultra wide angle len. As for the lens cap if you buy the 77mm filter then you would need a 77mm len cap, it you bought one to fit only one len than the cap for that len will fit not problem.
Allan
-
6th March 2012, 12:57 PM
#3
Re: B+W Filter mount confusion
Hi Allan
Thank you very much for your informative reply,
Best Wishes,Pat
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules